Crystal Universal Blocks

Product Details:

These are very & robust stand are used whenever the high-test measuring accuracy and an optimum rigidity is demanded. The extremely sturdy columns with the rigid guarantee high-test rigidity. Both stands have a novel clamping device for the
projection of scriber. "Crystal" Gauge has simple and rapid setting
of the stand and clamps and scriber in any position even at moderate tightening. A fine adjustment device allows rapid and easy setting at desired size. Suitable for pattern makers.

Specifications:

Product Details:

Universal Surface Gauges have many desirable features and are designed for a wide range of uses and are supplied in three sizes. The base is made from case – hardened steel,
ground on the bottom and at one end. There is a depression in each side for the thumb and fingers and the groove in the base adapts it for use on cylindrical as well as flat surfaces. There are two gauge pins frictionally held, which can be pushed down and used against the end of a surface plate on a T- slot for linear work. The fine adjustment feature makes it possible to obtain quick and accurate settings.
This adjustment is made by a knurled thumb screw which is located at the edge of the rocker. The rocker runs the 2/3rd length of the base and pivots against a stiff spring located at the rear end of the base.
The spindle which passes through rotating head or lower sleeve can be set above or below the base. The hardened and ground scriber can be set at any position on the spindle which in turn can be set at any angle. On the two larger sizes a 1/4" hole in the spring loaded scriber holder enables a dial indicator to be fitted.

Specifications:

Product Details:

Features:

• These may be used as single, in pairs or three at a time as the application requires. 
• Magnetic Universal blocks are precision ground, accuracy for flatness, parallelism and Squamess is within 0.005 mm. 

Product Details:

Features:

• A precision universal 'V non magnetic block for the most accurate Tool Room & Quality Control Work. 
• All the four Vees are parallel and their squareness to the end faces and height variations in the 'V' blocks are controlled in a matched pair. 
• Grade -A-Hardened & Ground made from alloy steel Hardness 55 HRC ± 2 HRC. 
• Grade-B-Made from extra dense and hard cast iron. 
• Universal type 'V' Blocks have four 90° 'V' & are supplied without clamps. 

Specifications: